Sunday, November 8, 2015

Wooden Grindstone Frame

Finally finished my grindstone setup for my blacksmithing demonstrations. I loosely copied the design from the one built by the Dominy’s (see attached picture).

The frame is white oak with drawbore mortice and tenon joinery. The frame is really solid and I’m surprised how easily the wheel rotates on the wooden bearings. The weight of the stone creates quite a bit of centrifugal force so once the stone is turning very little effort is needed to keep it going.

The handle is detachable and like the Dominy’s it is held on with a wooden thumb screw. The only part left to make is the water trough. I had a lot of overly complicated ideas for this, but I think I will keep it simple and just hollow out a log.       



4 comments:

Gorges Smythe said...

Looks GOOD!

Frontier Carpenter said...

Thanks Gorges

Unknown said...

Your grinder frame looks pretty cool. I have an antique grinding wheel that is mounted on a wooden frame. In my case the frame/stand has been worked and reworked to get more life out of it. Here is the link https://wordpress.com/post/jimthechairmaker.wordpress.com/726

Frontier Carpenter said...

Jim,
Nice grinder, I like the treadle arrangement.